refine unstructured mesh

January 11, 2004, 08:11

any body know about how to refine unstrurd mesh in gambit at particular location

January 12, 2004, 10:15

As far as I know this is not possible

January 12, 2004, 10:39

but in the gambit manual it is writen that it is possible

January 12, 2004, 19:46

I refine mesh by generating volume base base on surface mesh and surface mesh on line mesh. We can define the mesh density on line mesh.

January 12, 2004, 23:54

is there any method that we refine at particular location

January 21, 2004, 19:56

It is possible to refine the mesh in Gambit. All what you will do is to create another voulme just in where you want to refine and then split the original volume ( use connected option ) using this new volume. Therefore, mesh the small volume first with fine mesh and then mesh the rest of the domain. Export it to Fluent and ENJOY YOUR TIME

..Good Luck

January 11, 2004, 08:11	refine unstructured mesh	#1
s Guest Posts: n/a	any body know about how to refine unstrurd mesh in gambit at particular location

January 12, 2004, 10:15	Re: refine unstructured mesh	#2
Jeff Franklin Guest Posts: n/a	As far as I know this is not possible

January 12, 2004, 10:39	Re: refine unstructured mesh	#3
s Guest Posts: n/a	but in the gambit manual it is writen that it is possible

January 12, 2004, 19:46	Re: refine unstructured mesh	#4
xueying Guest Posts: n/a	I refine mesh by generating volume base base on surface mesh and surface mesh on line mesh. We can define the mesh density on line mesh.

January 12, 2004, 23:54	Re: refine unstructured mesh	#5
s Guest Posts: n/a	is there any method that we refine at particular location

January 21, 2004, 19:56	Re: refine unstructured mesh	#6
Jim Clancy Guest Posts: n/a	It is possible to refine the mesh in Gambit. All what you will do is to create another voulme just in where you want to refine and then split the original volume ( use connected option ) using this new volume. Therefore, mesh the small volume first with fine mesh and then mesh the rest of the domain. Export it to Fluent and ENJOY YOUR TIME..Good Luck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 07:21
[ICEM] Unstructured mesh refinement in ICEM	lost.identity	ANSYS Meshing & Geometry	3	April 28, 2013 12:10
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11
[Commercial meshers] Unstructured hex mesh	lr103476	OpenFOAM Meshing & Mesh Conversion	12	November 24, 2006 06:56