|December 22, 2009, 05:36||
Problem running parallel
Join Date: Nov 2009
Posts: 4Rep Power: 9
Hello, good morning,
We have a problem with a simulation we want to run
in parallel mode but a message error appears (enclosed txt), note that we are using Star CCM+.
The pc has two intel xeon processors (4 cores each one) and the
operating system is windows7 (64 bits); we have installated mpich for win 64 at this computer, is
it ok? We think the problem is at the mpi driver or something simmilar, highlight that on
serial mode the simulation works well, but relative slow.
Can you give us some solution?
Thank´s for tour attention.
We remain at your disposition for any doubt.
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem using property udfs in parallel mode||EllenW||FLUENT||0||June 23, 2009 17:18|
|problem loading UDF in parallel fluent||Tim||FLUENT||12||July 12, 2008 12:59|
|parallel UDF problem||kerem||FLUENT||2||June 20, 2006 06:56|
|PVM RSH parallel setup problem Windows XP||abe||CFX||11||January 30, 2006 06:10|
|parallel mode - small problem?||co2||FLUENT||2||June 1, 2004 23:47|