 |
 |
 |
|
|
|
[Sponsors] | ||||
November 18, 2018, 14:35
|
Having trouble meshing nozzle
|
#1 |
|
New Member
Join Date: Apr 2018
Location: Ohio, USA
Posts: 15
Rep Power: 9  |
Hi,
I am having trouble meshing a nozzle that I drew in Solidworks. It is not axis-symmetric. I have licenses for both Pointwise and Hypermesh. I would prefer a structured mesh, with points piled near the wall, but at this point, any mesh would be good. I will be using the mesh in OpenFOAM. The link below contains the Original Solidworks file as well as .step and .igs exports. https://drive.google.com/drive/folde...Xb?usp=sharing Thanks in advance! |
|
|
|
|
 |
| Tags |
| hypermesh, mesh 3d, openfoam, pointwise, solidworks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Convergent-Divergent Nozzle with MATLAB | Obad | Main CFD Forum | 8 | June 2, 2020 15:10 |
| Meshing a nozzle | parvaz747 | Mesh Generation & Pre-Processing | 3 | June 17, 2013 12:40 |
| [GAMBIT] Trouble meshing complex VOF geometry | RPJones | ANSYS Meshing & Geometry | 2 | February 14, 2011 19:54 |
| compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 02:45 |
| Trouble with meshing in Pro-am | NALLELI | Siemens | 1 | July 13, 2005 04:41 |
Linear Mode
