|
[Sponsors] |
March 30, 2023, 08:01 |
Are gmshToFoam und IdeasUnvToFoam dead?
|
#1 |
Member
Marco Bernardes
Join Date: May 2009
Posts: 57
Rep Power: 16 |
Dear colleagues,
I have tried to convert gsmh-msh and Salome-UNV mesh formats to foam but I could not get the simulation running. Beautiful meshes generated by gmsh returned lots of inconsistencies in gmshToFoam. IdeasUnvToFoam can convert UNV-meshes but the simulation just does not go on. Otherwise, if I use snappyhexmesh, the simulaiton run smoothly. Are gmshToFoam und IdeasUnvToFoam dead? This thread suggest a orientation problem: gmshToFoam warning - cannot match faces. However, I didn't understand that. Any comment is welcomed. Best, Masb |
|
Tags |
gmshtofoam ideasunvtofoam |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] New version of gmshToFoam? | stootoon | OpenFOAM Meshing & Mesh Conversion | 7 | February 14, 2022 09:01 |
[Salome] IdeasUNVToFoam - big meshes | malcolm.akner@hotmail.com | OpenFOAM Meshing & Mesh Conversion | 4 | March 3, 2021 14:00 |
[Salome] ideasUnvToFoam Error: Assertion `nouveau > -1' failed | GerhardHolzinger | OpenFOAM Meshing & Mesh Conversion | 0 | January 29, 2019 10:23 |
[Gmsh] gmshTofoam pbm with cyclicAMI | acahuzac | OpenFOAM Meshing & Mesh Conversion | 2 | October 20, 2014 03:53 |
[Salome] ideasUnvToFoam problem with internal groups | s.marcocalero | OpenFOAM Meshing & Mesh Conversion | 0 | May 31, 2013 11:48 |