Home > Forums > Special Topics > Mesh Generation & Pre-Processing

CFX solving approach

Mark Forums Read

Reply

Search this Thread

July 20, 2023, 08:53	CFX solving approach	#1
shingala New Member abhishek Join Date: Jun 2023 Posts: 12 Rep Power: 3	Hi all, does anyone know the difference between vertex-centered and cell-vertex based approach? which one CFX uses, if there is any difference. Does it solve governing equation only at node and then interpolate on face or does it also solves at cell centered?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help sought on axial compressor simulation	jyotir	OpenFOAM Running, Solving & CFD	0	November 17, 2021 10:49
Floating point exception error	lpz_michele	OpenFOAM Running, Solving & CFD	53	October 19, 2015 02:50
Cannot run the code properly: very large time step continuity error	crst15	OpenFOAM Running, Solving & CFD	9	December 14, 2014 18:17
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 05:24

All times are GMT -4. The time now is 12:31.