|
[Sponsors] |
[snappyHexMesh] Add layers- symmetric boundary condition |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 28, 2009, 05:38 |
Add layers- symmetric boundary condition
|
#1 |
Senior Member
Prapanch Nair
Join Date: Mar 2009
Location: Bangalore, India
Posts: 105
Rep Power: 17 |
Hi,
I have attached a rough picture of the domain I am planning to solve. The floor and ceiling mentioned in the fig are actually symmetry boundary conditions. So I want layers to be added all through the cylinder wall. But this doesn't happen( even after I played with a number of parameters). What I actually want is to have layers present from the floor till ceiling around the cylinder. For some reason the layers thin down towards the floor and ceiling and no layers are seen at the floor and ceiling. Can any one tell me if I can achieve what i want? Thank you prapanj Last edited by prapanj; May 28, 2009 at 05:40. Reason: wanted to add tags so that people can find this post by a search and get use out of it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
several fields modified by single boundary condition | schröder | OpenFOAM Programming & Development | 3 | April 21, 2015 05:09 |
External Radiation Boundary Condition for Grid Interface | CFD XUE | FLUENT | 0 | July 9, 2010 02:53 |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |