|December 10, 2010, 10:08||
No Surface-Layers on pipe with hexagonal cross sectional area
Join Date: Oct 2010
Posts: 7Rep Power: 8
I try to mesh a pipe with hexagonal cross-section with snappyHexMesh. The case is built up symmtrically, so you can see a trapezium-shaped pipe. I have defined one stl-File for the Wall of the pipe, one for the inlet and one for the outlet.
But there are two things going wrong with the Surface Layers (look at the pictures):
- only the topside of the pipe-wall is meshed with Surface-Layers, on the two sides nothing happens.
- and near inlet and outlet layers are not created, also.
Can somebody tell me, what is going wrong, or wich adjustments i can take, to get a complete layer-mesh all over the pipe-wall.
Thank You and Greets
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pipe Boundary Layers||Kieran Hood||Main CFD Forum||0||April 22, 2007 17:48|
|Build a pipe with different layers||Sun||CFX||2||June 9, 2005 18:33|
|My Revised "Time Vs Energy" Article For Review||Abhi||Main CFD Forum||2||July 9, 2002 09:08|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|