|
[Sponsors] |
January 19, 2017, 05:02 |
Refinement error
|
#1 |
Member
Vignesh Rajendiran
Join Date: Aug 2016
Location: Chennai, India
Posts: 62
Rep Power: 9 |
Hello Guys,
I was trying to mesh an stl file in sHM. But I am getting an error for the locationinMesh even though i used it correctly. I do not know why i am getting this error. I have attached two pictures and my log file(txt file) with this thread. In the picture i used the ruler command to show the point i specified in the locationinmesh command. If you could see the log file there are also many foam warnings mentioned regarding the polymesh tetdecomposition. Why am i getting this warning? The error i am getting is Code:
--> FOAM FATAL ERROR: Point (14 0.2 2) is not inside the mesh or on a face or edge. Bounding box of the mesh:(-16 -5 -0.31) (20 5 10) From function refinementParameters::findCells(const polyMesh&) const in file autoHexMesh/autoHexMeshDriver/refinementParameters/refinementParameters.C at line 106. Thank you Vignesh |
|
March 10, 2017, 10:19 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Have you looked at the output of blockMesh?
|
|
March 10, 2017, 14:46 |
|
#3 |
Member
Vignesh Rajendiran
Join Date: Aug 2016
Location: Chennai, India
Posts: 62
Rep Power: 9 |
Hi,
You guessed it right. I figured out the error was with the blockmesh domain definition and corrected it. I was able to run the simulation(after doing sHM) in a serial run. But when i tried to run in parallel i got an error stating "2D Mesh motion error". I could not figure out the reason for the error. If you have time please look at the following post and help me identify the error. I have attached the log file to the following post. https://www.cfd-online.com/Forums/op...ion-error.html |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure outlet boundary condition | rolando | OpenFOAM Running, Solving & CFD | 62 | September 18, 2017 06:45 |
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
How to install CGNS under windows xp? | lzgwhy | Main CFD Forum | 1 | January 11, 2011 18:44 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 05:07 |