 |
 |
 |
|
|
|
[Sponsors] | ||||
March 22, 2021, 10:28
|
MultiRegion Layer Mesh
|
#1 |
|
New Member
Join Date: Dec 2020
Posts: 9
Rep Power: 5  |
Hello,
I am trying to generate layers in my fluid mesh for a CHT analysis. I am following the tutorials and it mentions that you have to move the fluid mesh polymesh to the constant folder, run SHM with layers "true", then move the polymesh back to the fluid folder. What happens to the polymesh in the constant folder? According to this process, no polymesh remains in the constant folder. I cannot view the final mesh in paraview if no polymesh is present.... I wonder if I might have missed a step or something, any feedback would be appreciated. Thank you. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Creating very fine, high accuracy mesh with snappyHexMesh | JD_Welch | OpenFOAM Meshing & Mesh Conversion | 10 | July 5, 2023 11:50 |
| [snappyHexMesh] No generation of layer onto zerothickness surface | crubio.abujas | OpenFOAM Meshing & Mesh Conversion | 3 | October 25, 2022 03:20 |
| [snappyHexMesh] Bad/jagged mesh around intersection of two .stl bodies | MBttR | OpenFOAM Meshing & Mesh Conversion | 7 | October 14, 2016 03:57 |
| [snappyHexMesh] Propeller mesh not smooth | nortanapura | OpenFOAM Meshing & Mesh Conversion | 0 | May 16, 2014 03:26 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
