|
[Sponsors] |
May 8, 2023, 15:16 |
spikes between surfaces
|
#1 |
New Member
Join Date: Feb 2023
Posts: 3
Rep Power: 3 |
Hi Everyone,
i am working on IC Engine using snappyHexMesh. The problem i am facing occurs in the cases where the gap between the valve and the cylinderhead (valve seat) is very small. Spikes appears between the two surfaces. Anyone knows how to solve this problem? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SHM doesn't snap the boundary between two surfaces on same plane | decanter | OpenFOAM Meshing & Mesh Conversion | 4 | November 17, 2020 15:32 |
Combine part surfaces if along a specified plane | miragemobile | STAR-CCM+ | 1 | March 26, 2019 18:43 |
Extracting results on multiple surfaces | sunilpatil | FLUENT | 0 | October 21, 2018 11:15 |
NURBS surfaces on a wing | frossi | CFX | 5 | February 5, 2017 15:27 |
Modeling both radiation and convection on surfaces - Ansys Transient Thermal R13 | s.mishra | ANSYS | 0 | March 31, 2012 04:12 |