|
[Sponsors] |
January 30, 2024, 11:01 |
|
#21 |
New Member
Nafiz Ahmed Khan
Join Date: Nov 2023
Location: Canada
Posts: 18
Rep Power: 2 |
Hello Yann,
I couldn't find anything like the inside-out feature in CLIP, though it was also mentioned in their documentation. I've attached a screenshot for your reference. 1.PNG Regards, Nafiz |
|
January 30, 2024, 11:08 |
|
#22 |
Senior Member
Yann
Join Date: Apr 2012
Location: France
Posts: 1,068
Rep Power: 26 |
You have the "invert" option to tick to invert the selection.
But the question is just: when your setup your clip and click on "apply", do you get the area of interest? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[cfMesh] Edge problem | momod | OpenFOAM Community Contributions | 0 | May 19, 2023 11:51 |
[snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model | Saideep | OpenFOAM Meshing & Mesh Conversion | 5 | May 10, 2015 14:46 |
[GAMBIT] GAMBIT edge problem | SJD | ANSYS Meshing & Geometry | 4 | February 26, 2014 15:56 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |