|
[Sponsors] |
[mesh manipulation] Merge adjoining cellsregions |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 19, 2009, 10:01 |
Merge adjoining cellsregions
|
#1 |
Member
Niklas Winkler
Join Date: Mar 2009
Location: Stockholm, Stockholm, Sweden
Posts: 73
Rep Power: 17 |
Dear Foamers,
I have a submesh constructed as a fvMeshSubset from a 3D pipe geometry, figure below. The constructed mesh in this case is one cell thick to represent a 1D mesh. Since the cells in the bend are hanging loose OF sees the mesh as having several non-face-coupled regions. Is there a way to merge the cells in the bend to obtain a single "correct" mesh to calculate on? Regards /Niklas W |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
merge two connectors | v_herw | Pointwise & Gridgen | 1 | August 28, 2014 09:14 |
[ICEM] Two boxes connected by a cylinder, blocks merge where I don't want them to merge. | Polarbear | ANSYS Meshing & Geometry | 4 | April 30, 2014 15:21 |
[ICEM] Merge mesh - non manifold vertices | BrolY | ANSYS Meshing & Geometry | 4 | October 30, 2010 22:07 |
assemble the mesh | feixiangniao | ANSYS Meshing & Geometry | 2 | March 20, 2010 02:39 |
about merge mesh | lian | Main CFD Forum | 3 | February 29, 2008 10:47 |