|
[Sponsors] |
February 9, 2007, 12:07 |
Create mirror mesh
|
#1 |
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 317
Rep Power: 18 |
Hi,
I created a quarter of a cylinder (the cross section is a quarter of a circle) using blockMesh. The problem I am solving is true 3D, so, I would like to generate the mesh of the complete cylinder. Since this is symmetrical in X-plane and in Y-plane, how can I generate the mesh of the whole cylinder using "mirror" technique? Pei |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
[ANSYS Meshing] is it possible to create virtual edges on the blades | er_ijaz | ANSYS Meshing & Geometry | 0 | November 3, 2013 05:15 |
[DesignModeler] Design Modeller create surface | papis | ANSYS Meshing & Geometry | 0 | October 31, 2013 13:52 |
About create interface! | xinzhiyu2008 | STAR-CCM+ | 2 | August 6, 2010 20:47 |