 |
 |
 |
|
|
|
[Sponsors] | ||||
October 12, 2017, 16:12
|
RefineMesh with Progression
|
#1 |
|
Member
Join Date: Jun 2017
Posts: 73
Rep Power: 9  |
Hello everyone,
I would like to know if there is any possiblity to refine a mesh towards a face with a progression. For Example: I Have 4 cells in z-direction and using refineMesh would make 4x4 = 16 cells, which are equally big, but I would like to have the first cells 2 times bigger than the next one e.g. and so on. I know that you can give the lines of the mesh a progression but want to know if there is a possibily with refineMesh. Greetings, Friendly |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gmshToFoam Fatal error | KFUrzua | OpenFOAM Running, Solving & CFD | 3 | September 22, 2016 03:23 |
| [mesh manipulation] multiple calls to refineMesh parallel w/ dict failing | Regis_ | OpenFOAM Meshing & Mesh Conversion | 2 | June 4, 2015 13:44 |
| [mesh manipulation] checkMesh Erros after refineMesh | mgdenno | OpenFOAM Meshing & Mesh Conversion | 10 | October 14, 2014 05:16 |
| [mesh manipulation] Cannot get refineMesh to run in parallel | smschnob | OpenFOAM Meshing & Mesh Conversion | 2 | June 3, 2014 11:20 |
| [Gmsh] GMSH and OpenFOAM | derath | OpenFOAM Meshing & Mesh Conversion | 44 | September 4, 2008 05:09 |
Linear Mode
