|
[Sponsors] |
How to create the free surface interface in OpenFOAM for two phase flow. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 1, 2020, 03:50 |
How to create the free surface interface in OpenFOAM for two phase flow.
|
#1 |
Member
ESI
Join Date: Sep 2017
Posts: 46
Rep Power: 8 |
Now I am simulating CFD for my project but I don't know how to create the free surface interface in OpenFoam. My simulation has shown below the picture it is a two-phase flow simulation. My project requested have to use the DNS turbulence model to resolve.
[IMG]https://ibb.co/5sfFJW7] please give me any advice! thank you so much |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
homogeneous free surface flow with phase change. | Niru | CFX | 13 | December 26, 2013 10:27 |
How to create a free surface application in Openfoam ? | phuchuynh | OpenFOAM | 28 | September 21, 2011 03:35 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |