 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2022, 09:44
|
snappyHexMesh refinement visuals
|
#1 |
|
Member
Callum Guy
Join Date: Dec 2019
Location: Scotland
Posts: 44
Rep Power: 6  |
Hi Foamers,
question regarding refinement regions in SHM. I have a mesh (pictured in the attached coarse.png) that I can view in ParaView and see the refinement regions. Once I up the cell count for my simulations to be run on the server, I can no longer see the circular refinement region, even when I zoom in on ParaView (see attached fine.png and fine_zoomed.png). I've checked using VisIt too and that circular refinement region isn't visible. The checkMesh log on the simulations returns no errors. Any thoughts or ideas? Cheers, Callum |
|
|
|
|
|
May 26, 2022, 09:53
|
|
#2 |
|
Member
Callum Guy
Join Date: Dec 2019
Location: Scotland
Posts: 44
Rep Power: 6 |
Oh dear, I probably hit the refinement limit specified in snappyHexMeshDict.
Sorry for posting before properly investigating!! |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh running killed! | Mark JIN | OpenFOAM Meshing & Mesh Conversion | 7 | June 14, 2022 01:37 |
| problem with parallel calculations OF8 mpirun | otaolafr | OpenFOAM Programming & Development | 0 | January 5, 2021 07:33 |
| SimpleFoam & Theater | jipai | OpenFOAM Running, Solving & CFD | 3 | June 18, 2019 10:11 |
| killed "snappyHexMesh" | parkh32 | OpenFOAM Pre-Processing | 2 | April 8, 2012 17:12 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
Linear Mode
