|
[Sponsors] |
December 21, 2022, 06:43 |
Unit in scalarTransportFoam
|
#1 |
New Member
Jun Yin
Join Date: Jan 2019
Posts: 5
Rep Power: 7 |
Dear Forums,
I used scalarTransportFoam to simulate species transport in a tube. The species is defined between 0 and 1. But I saw same literature state that "we set species A is 1kg/m3". I was confused that how to set species with unit (kg/m3) in scalarTransportFoam? Anyone know the reason and how to set the unit? Thanks in advance! |
|
December 26, 2022, 10:00 |
|
#2 |
Member
Join Date: Jun 2020
Posts: 49
Rep Power: 5 |
As far as I am aware, the value between 0 and 1 represents the mass fraction of whichever species you are simulating, which is allway without units. The partial density of specie A can then be calculated by multiplying the mass fraction of A and overall density in each cell.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unit Normal Vector and Interface Jump ||.|| | mcfdma | OpenFOAM Programming & Development | 3 | February 20, 2023 09:00 |
unit of variables in binary diffusion coefficients equation | Weiqiang Liu | FLUENT | 0 | June 6, 2020 10:20 |
the unit of molar mass in fluent | Weiqiang Liu | FLUENT | 0 | June 11, 2019 16:54 |
Grid I Unit Normal and Grid J Unit Normal | pawansut | Tecplot | 4 | July 31, 2017 18:14 |
how to caculate the mass of impacting particles per unit area and per unit time? | xyq916 | CFX | 0 | October 8, 2015 08:55 |