 |
 |
 |
|
|
|
[Sponsors] | ||||
December 8, 2017, 09:27
|
fvOptions -call value from different region
|
#1 |
|
New Member
Join Date: Apr 2014
Posts: 24
Rep Power: 13  |
Hello everybody,
I'm working on heatTransfer simulations in which I want to define the heater-power depending on a sensor temperature that is measured in a different region. (Working with chtMultiRegionFoam and the codedSource in fvOptions...) Therefore I'm calculating the mean-temperature in the sensor but I'm not able to call this value in the heater-region. If the sensor is placed inside the heater-domain, than everything is working perfectly. Is there a possibility to call such a value or to transfer it into other region, or do I have to create an output-file? Thanks you! Tobi |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 14:26 |
| conjugate heat transfer in OpenFOAM | skuznet | OpenFOAM Running, Solving & CFD | 99 | March 16, 2017 05:07 |
| Taking too much for run | Grimoli | OpenFOAM Running, Solving & CFD | 5 | November 26, 2013 20:07 |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
Linear Mode
