|
[Sponsors] |
InterFoam ending with Floating Point Exception |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 20, 2023, 20:01 |
InterFoam ending with Floating Point Exception
|
#1 |
New Member
Mario Errico
Join Date: Oct 2016
Location: Rochester, NY
Posts: 2
Rep Power: 0 |
Hello all,
I am new to the forum and I have worked with openFoam for the last 2 months. I am running a transient multiphase simulation (interFoam11 under Ubuntu 22.04). The mesh is hand coded in 'blockMeshDict' using #calc to set up a parametric mesh for ease of cutomization. With a set of parameters interFoam runs fine in parallel but if I change just one parameter by a small amount interFoam crashes after running several steps with the Floating Point Exception. I used 'checkMesh' and it gives the OK. I understand that this error is probably due to a division by zero and that faulty BCs can be a cause. I have also tried using OF10 but I get the same error at approximately the same time step. I was wondering if there is a way to pinpoint the source of the error. Any help is greatly appreciated. As I am getting more familiar with the software I see myself helping out on the forum. Thanks a lot, Mario |
|
September 21, 2023, 01:48 |
|
#2 |
Senior Member
M
Join Date: Dec 2017
Posts: 642
Rep Power: 12 |
General troubleshooting:
1) visually check the created mesh, checkMesh is a hint, no guarantee 2) if 1) is ok, run again and let the solver put out results in the iteration(s) before the crash. Check the intermediate results for anything odd. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
icoFoam floating point exception (8) | leizhao512 | OpenFOAM Running, Solving & CFD | 7 | November 1, 2018 11:43 |
A floating point exception - SEM Model | yansheng | STAR-CCM+ | 1 | April 4, 2016 04:57 |
Floating point exception from twoPhaseEulerFoam | openfoammaofnepo | OpenFOAM Running, Solving & CFD | 1 | March 19, 2016 13:56 |
k-e & GAMG interFoam Schemitisation Stability Issue | JFM | OpenFOAM Running, Solving & CFD | 3 | December 1, 2015 05:58 |
Floating point exception (core dumped) for GAMG solver | yuhou1989 | OpenFOAM Running, Solving & CFD | 2 | March 24, 2015 19:28 |