|
[Sponsors] |
December 14, 2023, 13:32 |
Yawed Actuator Disk Model
|
#1 |
New Member
Nafiz Ahmed Khan
Join Date: Nov 2023
Location: Canada
Posts: 18
Rep Power: 2 |
Hello everyone,
I hope you all are doing well. I'm doing actuator disk model simulation and wanted to yaw the model at 30 degrees (say). I write it in the topoSetDic like below: 1.PNG But I found errors, which are attached below. 2.jpg How do I correct my errors? Any suggestions would be highly appreciated. Regards, Nafiz |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[IHFOAM] The IHFOAM Thread | Phicau | OpenFOAM Community Contributions | 392 | September 8, 2023 18:10 |
viewFactor radiation model stuck | shach934 | OpenFOAM | 1 | May 25, 2021 11:01 |
interFoam wave propagation and explosion of Courant number and residuals | ChiaraViola | OpenFOAM Running, Solving & CFD | 1 | June 26, 2019 05:36 |
manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 09:29 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |