|
[Sponsors] |
Not getting Simple flat plate simulation using sonicTurbFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 17, 2008, 00:23 |
Hi all,
I am doing a flat pla
|
#1 |
Member
Velan
Join Date: Mar 2009
Location: India
Posts: 50
Rep Power: 17 |
Hi all,
I am doing a flat plate simulation using sonicTurbFoam. I applied the boundary condition correctly (Hope :-)). But i am getting strange contours plot of pressure as well as temperature. You can take a look of pressure contour http://www.aero.iitb.ac.in:8081/~vel...m/pressure.png And also you can take a look on temperature contour http://www.aero.iitb.ac.in:8081/~vel...emperature.png You can see the boundary conditions and values which i have given as a input in the below link http://www.aero.iitb.ac.in:8081/~vel...atplate.tar.gz I have never seen this type of contour plots for simple flat plate with supersonic inlet conditions. I think somewhere mistake. Let me know if you need more information. Suggestion and ideas are welcome. - Velan |
|
September 19, 2008, 05:00 |
Hi all,
I wonder that no body
|
#2 |
Member
Velan
Join Date: Mar 2009
Location: India
Posts: 50
Rep Power: 17 |
Hi all,
I wonder that no body tried supersonic simulation using sonicTurbFoam in openFOAM . I thought this forum is used to discuss the problems and solution. - Velan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Re on a flat plate | Francis | Main CFD Forum | 9 | October 14, 2008 15:47 |
Flat plate | Mich | Siemens | 1 | April 15, 2006 04:43 |
Flat Plate And LES | Chetan Kadakia | FLUENT | 0 | December 2, 2001 21:44 |
FLAT PLATE | BOB | Phoenics | 1 | November 7, 2001 11:54 |
simulation of flat plate | cisong | FLUENT | 4 | September 12, 2001 11:10 |