 |
 |
 |
|
|
|
[Sponsors] | ||||
June 14, 2012, 05:19
|
Floating object tutorial
|
#1 |
|
New Member
Rehan amin
Join Date: May 2012
Posts: 3
Rep Power: 13  |
Hi friends,
the floating object tutorial in openfoam gives(shows) large heave motions but negligible lateral motions.Can somebody please tell me how to obtain enhanced lateral motions as well. |
|
|
|
|
|
June 16, 2012, 07:11
|
|
#2 |
|
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128  |
Greetings Rehan,
Well... the floating object tutorial is known to be a very hard subject to deal with. Search here in the forum for "floatingObject" and you'll probably find out that there have been many people giving up on this subject with OpenFOAM, because this is a very hard simulation to reconfigure. It works fine as-is, but as soon as you lift/lower the box a little bit or change anything in the geometry of the box (bit bigger/smaller, wider and so on), it will crash soon afterwards. So, go search!  Best regards, Bruno
__________________
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The floating object tutorial | Leech | OpenFOAM Running, Solving & CFD | 22 | November 24, 2019 11:28 |
| [foam-extend.org] Error compiling OpenFOAM-1.6-ext | Canesin | OpenFOAM Installation | 137 | January 20, 2016 14:56 |
| Floating object tutorial case in OpenFOAM 1.7 | sega | OpenFOAM Running, Solving & CFD | 11 | February 9, 2012 04:29 |
| Compilation error OF1.5-dev on Suse10.3 | darenyang | OpenFOAM Installation | 0 | April 29, 2009 04:55 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Linear Mode
