|
[Sponsors] |
February 1, 2021, 19:44 |
OpenFOAM wave tutorial question.
|
#1 |
New Member
seo
Join Date: Jan 2021
Posts: 4
Rep Power: 5 |
Hello.
I am currently doing a tutorial at interFoam/laminar/waves at OpenFOAM. Unlike the dambreak tutorial, when you start the calculation, the files postProcessing, Processor0, and Processor1 are created. Is there anyone who would be grateful to explain this part? And there is another one. In the case of damdreak, the calculation starts with blockMesh -> Setfield -> interFoam in the terminal, but in the case of waves, the calculation is not performed by following the same procedure. Is there a way to start the calculation in a similar way to dambreak rather than ./Allrun? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 3 | November 14, 2023 11:58 |
CFD in Naval Hydrodynamics, Off-Shore and Wave Modelling with OpenFOAM | hjasak | OpenFOAM Announcements from Other Sources | 2 | February 13, 2017 04:59 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
New OpenFOAM Forum Structure | jola | OpenFOAM | 2 | October 19, 2011 06:55 |
Adventure of fisrst openfoam installation on Ubuntu 710 | jussi | OpenFOAM Installation | 0 | April 24, 2008 14:25 |