|
[Sponsors] |
[OpenFOAM] Paraview 4.1 - Unable to center colorbar title |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 20, 2014, 04:43 |
Paraview 4.1 - Unable to center colorbar title
|
#1 |
Member
Laurent Fitschy
Join Date: May 2011
Posts: 40
Rep Power: 14 |
Hi,
With paraview 3, I was able to center the colorbar title by scaling horizontally the colorbar (see picture 1 &2) But with Paraview 4, I am not able to do it anymore ! Does anyone have an advice ? Thanks, Laurent. |
|
March 23, 2014, 11:26 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Greetings Laurent,
For better or for worse, that is no longer possible, at least not with a normal ParaView scalar bar. And today I'm not inspired to try and figure out how to use a customized vtkScalarBarWidget via Python, which should provide more control. You can open a feature request at the ParaView bug tracker, asking for this feature back. Because this scalar bar representation in ParaView is intentionally different from the one in VTK, in an attempt to make it easier to use. Best regards, Bruno
__________________
|
|
March 24, 2014, 02:39 |
|
#3 |
Member
Laurent Fitschy
Join Date: May 2011
Posts: 40
Rep Power: 14 |
Hi Bruno,
Thank you for your reply. I followed your suggestion and posted my feedback on ParaView web site : http://paraview.uservoice.com/forums...alar-bar-title Regards, Laurent. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
6dof for rotation of turbine: unable to fix the center | Havinh | Fluent UDF and Scheme Programming | 0 | August 5, 2015 05:35 |
[Other] Unable to center propeller in cylinder.. | orkavic | OpenFOAM Meshing & Mesh Conversion | 2 | December 16, 2013 12:34 |
[General] How to get cell center data in Paraview | sdharmar | ParaView | 1 | January 30, 2013 10:56 |
Plotting Residuals | ata | OpenFOAM | 12 | July 8, 2011 02:50 |
help needed about phase change | Yanhu Guo | Main CFD Forum | 4 | January 23, 2001 23:16 |