|
[Sponsors] |
[General] Data processing problem with Paraview |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 29, 2016, 21:48 |
Data processing problem with Paraview
|
#1 |
New Member
siyang zhang
Join Date: Mar 2016
Posts: 3
Rep Power: 10 |
Hi guys:
I've done a simulation, which is about a collision between two particles and created a bunch of .vtu files of the simulation. Paraview can load these files and provide me the contact force, velocity and stress information in .csv files , while I don't know how to find the equivalent total force (as a vector), its point of application and its magnitude for each step during the collision. Anybody have any idea about how to get these values in the simulation? Thank you so much if you can provide some help! Simon |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] New to ParaView, several questions on processing | Crank-Shaft | ParaView | 0 | November 24, 2014 07:23 |
[OpenFOAM] Paraview display problem | jiejie | ParaView | 4 | October 13, 2013 21:29 |
How to assign the inlet B.C using a bunch of data set for an unsteady problem? | ali8500 | CFX | 3 | March 28, 2012 18:41 |
[OpenFOAM] extracting data from paraview | tharem | ParaView | 1 | January 17, 2011 23:45 |
paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 21:41 |