|
[Sponsors] |
December 8, 2018, 00:42 |
radial slice on the blade
|
#1 |
Member
sajad alimardani
Join Date: Feb 2018
Posts: 31
Rep Power: 8 |
Hello to everybody,
I computed the flow wake of propeller. I need to make a slice on the blades how i can Measure the Components average velocity(Tangential,Radial,normal) on this section.(same the picture) x/D=0.1,0.2 The angle between -50 ,22 .(-50<θ>22) Best regards, sajad. |
|
December 30, 2018, 16:02 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Quick answer: You can use the "Clip" filter twice, sort of like this in the ParaView Pipeline Browser:
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plot Pressure along the blade section of propeller at various radial location | surajp92 | Main CFD Forum | 1 | October 29, 2017 20:47 |
[TurboGrid] Slotted rotor Blade using Turbogrid | drcsm | ANSYS Meshing & Geometry | 0 | March 15, 2016 00:26 |
Problem in conducting CFD of analysis of wind turbine blade | atulpat | CFX | 16 | August 17, 2013 04:09 |
Compressor Blade Analysis in Ansys CFX | LynchMobster47 | Main CFD Forum | 0 | April 10, 2012 22:43 |
radial turbine blade simulation with dynamic mesh 6dof(fluent) | mamyjooooon | FLUENT | 0 | April 7, 2011 14:28 |