 |
 |
 |
|
|
|
[Sponsors] | ||||
May 4, 2019, 11:05
|
Coloring Isosurface Paraview
|
#1 |
|
New Member
Join Date: May 2019
Posts: 1
Rep Power: 0  |
Hi to everyone,
I have plotted the contour of a variable, for example component u of the velocity, now when i am setting the coloring value in Coloring section i can not select as reference the variable v, but only the other ones. Any suggestions? Thank you in advance, Daniele Last edited by DanPar; May 6, 2019 at 05:57. |
|
|
|
|
 |
| Tags |
| contour plots, dat file, tecplot 360 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Tabulated thermophysicalProperties library | chriss85 | OpenFOAM Community Contributions | 62 | October 2, 2022 03:50 |
| [swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
| [OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0 | tlcoons | OpenFOAM Installation | 13 | April 20, 2016 17:34 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
Linear Mode
