|
[Sponsors] |
November 14, 2019, 06:51 |
How to remove part of a plane
|
#1 |
New Member
Join Date: Nov 2019
Posts: 1
Rep Power: 0 |
Hi everyone.
I have this image of resistivity data and a plane containing the topographic data and aerial photo overlain on top. Unfortunately, there is interference between the resistivity data and the plane. Is there a way of cutting out the section of a plane in which the resistivity data is located, so that the interference goes? |
|
February 3, 2020, 14:55 |
|
#2 |
Member
Join Date: Nov 2015
Posts: 38
Rep Power: 10 |
A quick fix may be to use a "Transform" filter to move the plane with imagery down in the z-direction a negligible amount to "separate" the data sets.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Combine part surfaces if along a specified plane | miragemobile | STAR-CCM+ | 1 | March 26, 2019 18:43 |
Using a variable to set a plane | wjbvg5 | EnSight | 1 | September 1, 2017 16:51 |
Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 09:16 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |