[OpenFOAM] Paraview doesn't allow adjusting opacity

huanghai · July 16, 2020, 04:40

Hi all,

I came across a weird issue in paraview.

I was trying to achieve semi-transparent effect by adjusting opacity level (Properties panel -> Styling -> Opacity), however the entire visual would disappear as long as opacity is not 1.

For example, the whole layer would disappear if I set Opacity to to 0.5 or even 0.99, and the layer would reappear as 100% opaque if I change Opacity level back to 1.

Apart from this, everything else works perfectly. I assume it's a problem with my environment / graphic or a paraview setting I overlooked?

Has anyone experienced this problem before. I appreciate your help very much!

Regards,
Huanghai

flotus1 · July 21, 2020, 04:28

Sounds like a graphics driver issue.
After trying out the latest version of PV, make sure you have the correct and most recent driver installed for your particular GPU.

huanghai · August 27, 2020, 11:08

Quote:

Originally Posted by flotus1

Sounds like a graphics driver issue.
After trying out the latest version of PV, make sure you have the correct and most recent driver installed for your particular GPU.

Yes you're right. It was a graphic driver issue.
I installed the correct GPU driver then rebooted, it solved the problem.

Thanks very much!

July 16, 2020, 04:40	Paraview doesn't allow adjusting opacity	#1
huanghai New Member Join Date: Nov 2019 Posts: 5 Rep Power: 7	Hi all, I came across a weird issue in paraview. I was trying to achieve semi-transparent effect by adjusting opacity level (Properties panel -> Styling -> Opacity), however the entire visual would disappear as long as opacity is not 1. For example, the whole layer would disappear if I set Opacity to to 0.5 or even 0.99, and the layer would reappear as 100% opaque if I change Opacity level back to 1. Apart from this, everything else works perfectly. I assume it's a problem with my environment / graphic or a paraview setting I overlooked? Has anyone experienced this problem before. I appreciate your help very much! Regards, Huanghai

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Paraview doesn't allow adjusting opacity	huanghai	OpenFOAM Post-Processing	3	August 27, 2020 11:13
[OpenFOAM.org] Two different versions of ParaView with same OpenFOAM release	FJSJ	OpenFOAM Installation	2	July 23, 2017 05:48
Installing OpenFOAM and ParaView in VirtualBox(Ubuntu on Win8)	chrisb2244	OpenFOAM Installation	2	August 21, 2013 13:24
Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2?	lentschi	OpenFOAM Installation	1	March 9, 2011 02:32
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41

July 21, 2020, 04:28		#2
flotus1 Super Moderator Alex Join Date: Jun 2012 Location: Germany Posts: 3,430 Rep Power: 49	Sounds like a graphics driver issue. After trying out the latest version of PV, make sure you have the correct and most recent driver installed for your particular GPU.