Home > Forums > Mesh Generation & Pre-Processing Software > Pointwise & Gridgen

Meshing turbomachinery blade domain in Gridgen

Mark Forums Read

Reply

Search this Thread

September 3, 2007, 08:33	Meshing turbomachinery blade domain in Gridgen	#1
Hasham H Chougule Guest Posts: n/a	Hi All, How do I mesh a turbomachinery blade domain in Gridgen? I have the hub curve, shroud curve and blade profiles points. The tutorial has a glf script written for generating mesh for a simple axial turbine blade. I also need to create a tip gap. How do I create such a geometry in Gridgen using the above available points? Thank you Best Regards Hasham

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 07:22
Concave meshing in Gridgen	Joel	Pointwise & Gridgen	1	July 28, 2007 15:07
Anisotropic Tetrahedral Meshing using Gridgen?	Turbomachinery	Pointwise & Gridgen	2	May 7, 2007 07:13
impressive meshing by gridgen	sam	Pointwise & Gridgen	1	October 20, 2006 03:07
meshing turbomachinery	clo	Main CFD Forum	0	May 19, 2006 09:41

All times are GMT -4. The time now is 11:38.