 |
 |
 |
|
|
|
[Sponsors] | ||||
March 22, 2019, 12:51
|
Structured domain with internal holes
|
#1 |
|
New Member
Alexander
Join Date: Mar 2019
Posts: 2
Rep Power: 0  |
Hello,
I'm almost completely new to the pointwise software, and I have this problem that should be quite easy to solve. I want to create a structured domain, that i can later extrude, where the internal six holes, as seen in the picture, is not part of that domain. If i make a domain selecting all connectors, a square structured domain without holes appear. Is there a easy solution to this i'm missing? Thank you! |
|
|
|
|
| Tags |
| domain, mesh, structured |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to mesh a domain around a rounded geometry with structured grid | quarkz | Pointwise & Gridgen | 2 | March 5, 2019 22:05 |
| Monte Carlo Simulation: H-Energy is not convergating & high Incident Radiation | volleyHC | CFX | 5 | April 3, 2016 05:41 |
| Floating point exception: Zero divide | liladhar | CFX | 11 | December 16, 2013 04:07 |
| Named selection for internal surfaces in the domain | Ahmed Saeed | CFX | 1 | November 20, 2013 09:32 |
| [ICEM] Structured mesh for a combustor - dilution holes issue | Andrea1984 | ANSYS Meshing & Geometry | 0 | October 28, 2013 09:20 |
Threaded Mode
