|
[Sponsors] |
November 24, 2003, 11:00 |
Problems with different boundaries
|
#1 |
Guest
Posts: n/a
|
Hello,
I have a problem with my boundary conditions. I'm working with the multi reference frame and two pressure boundaries pressure at regi 1, and regi 2; options are default. With regi 1=0 and regi 2=0 the result is very good and the airflow [m^3/h] is also realistic. But with regi 1 =1 and regi 2=86 the calculation diverges. thank you Sven |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] ParaView Postprocessing problems with cyclic boundaries | christian | ParaView | 10 | June 26, 2009 05:49 |
Problems with Fluent on simple 1D problems | agg | FLUENT | 3 | November 21, 2008 11:55 |
UDF and boundaries | deneb | FLUENT | 1 | October 24, 2008 03:32 |
[blockMesh] Problems with cyclic boundaries in blockMesh | marhamat | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2007 10:06 |
problems replacing old boundaries | Jared | Siemens | 4 | August 5, 2005 19:36 |