 |
 |
 |
|
|
|
[Sponsors] | ||||
found crack in prostar but no crack in CCM+ ?? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 2, 2006, 15:18
|
found crack in prostar but no crack in CCM+ ??
|
#1 |
|
Guest
Posts: n/a
|
I generated polyhedral mesh in StarDesign. Then imported the .CCM to starcd v4 and CCM+ 2.0. In v4, I found cracks in the model. In CCM+ 2.0, the mesh was good. Did anyone encounter this problem ? This is weird. Did I make any mistakes ?
-E.Ingear |
|
|
||
|
August 2, 2006, 21:44
|
Re: found crack in prostar but no crack in CCM+ ??
|
#2 |
|
Guest
Posts: n/a
|
I think because there is no couple match in ccm+ so that there is no crack.
|
|
|
|
||
|
August 2, 2006, 23:45
|
Re: found crack in prostar but no crack in CCM+ ??
|
#3 |
|
Guest
Posts: n/a
|
Just ignore it. I observed the same with some meshes generated with ccm+ , but there was no problem running the calculation.
|
|
|
|
||
|
August 3, 2006, 13:12
|
Re: found crack in prostar but no crack in CCM+ ??
|
#4 |
|
Guest
Posts: n/a
|
Thank You.
|
|
|
|
||
|
October 23, 2006, 09:37
|
Re: found crack in prostar but no crack in CCM+ ??
|
#5 |
|
Guest
Posts: n/a
|
hi i need to crack for:
1- mycafecup 2- softperfect bandwidth manager thank,s |
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crack problems | Sara | Siemens | 3 | August 6, 2008 12:18 |
| Crack error in STAR-CD | Sachin | Siemens | 3 | April 17, 2008 01:13 |
| crack in sector mesh | escapist | Siemens | 2 | May 19, 2005 07:25 |
| How to crack this problem | Lee | Siemens | 2 | September 12, 2003 10:40 |
| Crack problems again | Carlos Saraiva | Siemens | 2 | January 31, 2003 04:12 |
Linear Mode
