|
[Sponsors] |
August 16, 2012, 11:14 |
in-place interface problem
|
#1 |
New Member
ajay.mighty@gmail.com
Join Date: Mar 2011
Posts: 1
Rep Power: 0 |
I used in-place interface between the porous region and fluid region for my problem. I even initialized the interfaces. But there is no connectivity between the slave and the master faces.
could any one tell me the reason? |
|
August 16, 2012, 15:33 |
|
#2 |
Senior Member
Join Date: Dec 2010
Posts: 135
Rep Power: 15 |
Just a guess, maybe imprint the interfaces and try it again! If there is no gap between these interfaces there should be a connection
|
|
September 9, 2012, 12:05 |
|
#3 |
Senior Member
Sergei
Join Date: Dec 2009
Posts: 261
Rep Power: 21 |
You can check an interface by eye. As you pick it in the model tree the faces are highlighted with a color so that you could see if they are right or not. Besides, check a tolerance value within your interface.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Problem with interface | Roland R | CFX | 6 | March 1, 2018 08:24 |
problem with interface in heat conduction | josefguerreroj | ANSYS | 1 | June 8, 2013 20:19 |
Problem with interface in a wind turbine simulation | be_inspired | FLUENT | 2 | March 7, 2011 23:46 |
Interface problem | Tomislav | FLUENT | 4 | May 23, 2006 00:49 |