|
[Sponsors] |
September 2, 2016, 01:13 |
y+ value ~1 question
|
#1 |
New Member
Edward Kraft
Join Date: Dec 2014
Posts: 11
Rep Power: 11 |
So the wall function I'm using requires a y+ value to be as close to 1 as possible. If my max y+ after simulation is around .02, does that change my results significantly than if my max y+ was lets say 0.9? Does the closer max y+ is to 1, the better the results, or as long as my max y+ is less than one, I'm good to go? Thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about symmetry in Autodesk Cfd 2016 | ecto | Autodesk Simulation CFD | 0 | October 20, 2015 04:16 |
small question about the functionalities of topological changes in OpenFoam | ngj | OpenFOAM Running, Solving & CFD | 2 | February 28, 2013 10:02 |
Question Re Engineering Data Source | imnull | ANSYS | 0 | March 5, 2012 13:51 |
internal field question - PitzDaily Case | atareen64 | OpenFOAM Running, Solving & CFD | 2 | January 26, 2011 15:26 |
Poisson Solver question | Suresh | Main CFD Forum | 3 | August 12, 2005 04:37 |