|
[Sponsors] |
Why imprint make my model's surface not show? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 12, 2022, 21:39 |
Why imprint make my model's surface not show?
|
#1 |
New Member
Join Date: Apr 2022
Posts: 10
Rep Power: 4 |
I have a model made of some walls and water fluid, I use the imprint function in boolean for all the walls to get their contacts a,but there has been produced to a surface in parts and region for both of walls and fluid,the surface just created is their interface.And some sufaces in my original model can not show,I need to creat a report for some surfaces to get their pressure.So,what should i do? Thank u!
|
|
April 12, 2022, 22:52 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,676
Rep Power: 66 |
Go to derived parts, create, section, arbitrary...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Defects in surface imprint | cibi | FLUENT | 1 | May 19, 2023 16:24 |
Error in gmshToFoam on ESI v2106 | siefer92 | OpenFOAM Programming & Development | 4 | July 17, 2021 05:11 |
how to calculate water average velocity in free surface models | hmasenger | CFX | 22 | October 30, 2019 19:28 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[ICEM] make tip gap surface, ICEM | Jonathan | ANSYS Meshing & Geometry | 2 | July 3, 2014 11:06 |