|
[Sponsors] |
June 14, 2023, 21:45 |
Rad Pressure Drop Correlation Issue
|
#1 |
New Member
Join Date: Apr 2023
Posts: 1
Rep Power: 0 |
I am new to CAE, start with Rad pressure drop simulation and would like to correlate to physical result, but my simulation result always lower than the physical result.
I tried increase the number of prism layers from 2 to 8, result increase a little but not too much. screen shot is the physical models i used, also simulation I set up this one inlet and one outlet, set constant inlet flow and 0 KPA for outlet Does anyone could point out which I need to look into and change the value or any wrong on physical? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cyclone Pressure Drop Too low | sirsammie72 | FLUENT | 6 | August 22, 2020 07:56 |
Pressure drop and temperature issue | msnadeem | FLUENT | 3 | September 24, 2019 02:02 |
Pressure drop using Fan type BC | Alexis Sack | OpenFOAM Running, Solving & CFD | 2 | September 22, 2014 09:18 |
Mass flow rate prediction of Purge control valve using set pressure drop | enr_venkat | CFX | 11 | February 27, 2014 11:30 |
How to study pressure drop of continous phase in VOF model | sajeesh | FLUENT | 4 | February 5, 2014 22:01 |