|February 28, 2012, 20:53||
Mechanism in Star CCM+
Join Date: Feb 2012
Posts: 3Rep Power: 7
What would be the best way to model a mechanism in Star CCM+? The model has already been created in ProEngineer. The mechanism involves a casing with inlet and outlet holes where a constant water pressure of 50 psi will be at the inlet hole. Inside will be an axle with a turbine and cam fixed to this axle. The goal is to observe the fluid motion/gain data. (The cam acts as a valve which opens and closes the outlet hole.)
I'm very new with CFD and I'm not sure how complicated this will be to set up. How do I ensure the cam and turbine will spin with the axle? How do I set up the boundary conditions?
Any help is much appreciated--whether it be a link to similar tutorials or general instructions on how to approach this system. Also, if further clarification is needed, do not hesitate to ask.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Using starToFoam||clo||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||33||September 26, 2012 04:04|
|Fluent Vs Star CCM||firda||Main CFD Forum||3||February 26, 2011 03:51|
|StarToFoam error||Kart||OpenFOAM Meshing & Mesh Conversion||1||February 4, 2010 05:38|
|error in star ccm||maurizio||CD-adapco||3||October 16, 2007 05:17|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|