|
[Sponsors] |
June 24, 2011, 05:25 |
Problem about using es-ice
|
#1 |
New Member
Shiyu Zhou
Join Date: Jun 2011
Posts: 2
Rep Power: 0 |
I want do the engine CFD simulation by star-cd.
Now I made a geometry by catia, and put into the es-ice to create the template. Finish creating the template I mapping the template with the geometry. When finish the mapping, I checked the negative volume.If it existing,I smooth again.(sometimes I smooth so many times but the negative volume still exist,is there any way to make it easier).When I finish the mapping and also check the negative volume is 0.Then I use star setup to create the moving mesh.After that I created the result at TDC to check the negvol still exist.At this time hundereds of negative exist around the valve.This problem confused me so many days.Is anyone could give me some hint to solve this problem? |
|
July 14, 2011, 07:22 |
|
#2 |
New Member
AB
Join Date: Jun 2010
Posts: 21
Rep Power: 15 |
why do u mapp.
Is it a very complicated geometry? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |