|
[Sponsors] |
Q. Regarding the consideration of RPM value to validate assembly. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 14, 2020, 01:33 |
Q. Regarding the consideration of RPM value to validate assembly.
|
#1 |
New Member
SaiPrasad
Join Date: Dec 2017
Posts: 17
Rep Power: 8 |
Consider there is an exhaust assembly consists of motor and blower. Motor rpm is 3000 and blower rpm is 2500.
I am performing modal analysis to check the characterstics of vibrations based on natural frequencies. In this particular problem, which rpm has to be considered such that based on that I need to improve the natural frequencies away from operating frequency to safeguard the assembly from failure. If I consider blower operating frequency and try to improve, somewhere the coincidence of motor operating frequency happens . Which rpm has to be considered in this problem . Please let me know ur comments on this case . Thanku & regards SaiPrasad Chowdavaram |
|
October 14, 2020, 16:54 |
|
#2 |
Senior Member
Join Date: Nov 2015
Posts: 246
Rep Power: 11 |
Both frequencies are important, you can not neglect one of them. Usually we try to move natural frequency +/- 10% away. Therefore your dangerous zone is 37,5-55 Hz because two dangerous zones from the engine and blower overlap.
|
|
October 15, 2020, 03:49 |
|
#3 |
New Member
SaiPrasad
Join Date: Dec 2017
Posts: 17
Rep Power: 8 |
@karachun sir, thanku for the reply. So, according to ur explaination u meant to say I need to go ahead of motor operating such that both rpm's can be compromised . Plz correct me if I wrong on ur point sir .
|
|
October 15, 2020, 17:57 |
|
#4 |
Senior Member
Join Date: Nov 2015
Posts: 246
Rep Power: 11 |
Yes, if the first mode of exhaust assembly is higher than 55 Hz then structure is safe, resonance not possible.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[foam-extend.org] foam-extend-4.1 cannot compile on Centos8 | Ya_Squall2010 | OpenFOAM Installation | 2 | July 22, 2020 02:03 |
[foam-extend.org] paraview not runing? (foam extended 3.2 and ubuntu 15.04) | Milan2013 | OpenFOAM Installation | 23 | April 20, 2017 05:49 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
Install OF 1.6.ext on Arch based distribution | miro2000 | OpenFOAM Installation | 4 | October 9, 2013 14:39 |
OpenFoam 1.6-ext - RPM build errors | preibie | OpenFOAM | 12 | September 8, 2011 03:12 |