|
[Sponsors] |
October 31, 2020, 13:21 |
Wrong results for 2-way FSI in ANSYS
|
#1 |
Member
Join Date: Oct 2017
Posts: 35
Rep Power: 8 |
Hi,
I made 1-way and 2-way FSI analysis for blades of an axial turbine with ANSYS and then calculated the total deformation for both cases. For 1-way FSI I think the result is okay and logical. But for 2-way FSI I think there is a problem with the left blade. I attach a figure of both results. What’s wrong with the 2-way FSI? All the conditions are the same. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
twoPhaseEulerFoam fluidized bed wrong results | FabianB | OpenFOAM Running, Solving & CFD | 0 | June 14, 2017 03:48 |
udf error | srihari | FLUENT | 1 | October 31, 2016 14:18 |
fully developed channel flow with kOmega, wrong results | boshynova | OpenFOAM Programming & Development | 1 | April 20, 2016 10:54 |
error about fsi in CFX and ANSYS | WANGFIRE | CFX | 1 | April 21, 2015 01:48 |
FSI using CFX and ANSYS | Bi Chang | CFX | 2 | May 10, 2005 04:47 |