|
[Sponsors] |
February 15, 2017, 04:07 |
Radial compressor simulation
|
#1 |
New Member
Mayssoun
Join Date: Feb 2017
Posts: 1
Rep Power: 0 |
Hi all,
I'm an engineering student and i'm doing a final year project on SU2. The purpse of the project is to simulate both radial and axial 3D compressors on SU2. Now, I'm working on the radial compressor, the problem is that i don't have a mass flow when I run the simulation. I tried both mass flow inlet and Total conditions. My mesh file is in CGNS and with Fluent the simulations worked quit well. Any help ? this is my last configuration file based on the test case 2D centrifugal blade. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Formulation of the Radial Acutation Disk Source | antar | OpenFOAM Programming & Development | 3 | November 3, 2019 02:20 |
[ANSYS Meshing] Mesh refinement in both axial & radial direction for 3D annular-tubular geometry | trbprnz | ANSYS Meshing & Geometry | 2 | November 8, 2016 07:00 |
Radial Equilibrium | MissCFD | CFX | 1 | March 25, 2015 17:49 |
[ICEM] Radial Turbine | spl | ANSYS Meshing & Geometry | 0 | February 2, 2015 04:07 |
Radial Load calculation | pump_passion | CFX | 3 | March 31, 2010 17:51 |