 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2017, 17:35
|
SU2 _ MPI Problem
|
#1 |
|
Member
Mehdi Mortazawy
Join Date: Mar 2017
Posts: 30
Rep Power: 9  |
Hello All,
I was wondering if there is any control over how MPI divides the mesh when running on a HPC cluster. Sometimes when I run a ~7million cell 2D mesh It works with 200 cores but when I go any value above (lets say 360) it either gets stuck at the “Communicationg....halo layers) step or throws a MPI FATAL ERROR. Any comments or suggestions are appreciated. Mehdi Last edited by mhd_mrt; November 4, 2017 at 08:47. Reason: Error changed |
|
|
|
|
 |
| Tags |
| error, mpi, parallel computation, su2 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mellanox ConnectX-3 Infiniband problem with Platform MPI 9.1.3 | digitalmg | Hardware | 13 | January 23, 2019 14:28 |
| SU2 Parallel Computation problem | Gramanzini | SU2 | 5 | September 29, 2018 12:32 |
| Data Writing Problem in Intel MPI | xuegy | OpenFOAM Running, Solving & CFD | 2 | May 11, 2018 03:19 |
| MPI problem when using snappyHexMesh | Mohamed Mousa | OpenFOAM Running, Solving & CFD | 3 | September 17, 2017 11:45 |
| CFX parallel hp MPI problem | fluidmechanics | CFX | 5 | June 19, 2013 19:05 |
Linear Mode
