 |
 |
 |
|
|
|
[Sponsors] | ||||
August 5, 2020, 06:30
|
tecplot output file error v7.0.6
|
#1 |
|
New Member
Khvalichev Sergey
Join Date: Aug 2020
Posts: 1
Rep Power: 0  |
I cannot open the tecplot output szplt file and a .dat file. Error text is simular to output file error v7.0.3
+-----------------------------------------------------------------------+ | File Writing Summary | Filename | +-----------------------------------------------------------------------+ |Tecplot binary surface |surface_flow.szplt | 0: Error finishing Tecplot file output. +-----------------------------------------------------------------------+ Offered solution didn`t help, there is a marker in MARKER_PLOTTING |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
| SparceImage v1.7.x Issue on MAC OS X | rcarmi | OpenFOAM Installation | 4 | August 14, 2014 07:42 |
| centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 02:41 |
Linear Mode
