 |
 |
 |
|
|
|
[Sponsors] | ||||
April 28, 2017, 08:25
|
ICEM CFD meshing lock edge mesh size
|
#1 |
|
New Member
vigneshwaran
Join Date: Apr 2017
Posts: 5
Rep Power: 9  |
i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...
so i was able to get good mesh near inlet or outlet.... i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked..... is there a way to lock one end edge mesh size and do the other......  please give certain idea thank u for any reply.... |
|
|
|
|
|
April 28, 2017, 08:27
|
correction for better understanding
|
#2 |
|
New Member
vigneshwaran
Join Date: Apr 2017
Posts: 5
Rep Power: 9 |
i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...
so i was able to get good mesh near inlet or outlet.... but not on both side of 3d meshing i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked..... is there a way to lock one end edge mesh size and do the other...... please give certain idea thank u for any reply.... |
|
|
|
|
|
 |
| Tags |
| ansys meshing, icem cfd |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| multi-body meshing with ICEM CFD | Espilet | ANSYS Meshing & Geometry | 0 | September 19, 2015 15:49 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| [snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
Linear Mode
