|
[Sponsors] |
August 15, 2017, 20:27 |
İnflation Boundary Selection
|
#1 |
New Member
Rakuen
Join Date: Oct 2011
Posts: 6
Rep Power: 14 |
Hi,
I am trying to give inflation layer around fan blades but it does not accept faces. It just appears no selection. Scope geometry is my mrf domain which is fluid zone. Where am I doing wrong? Last edited by Rakuen; August 16, 2017 at 06:12. |
|
August 16, 2017, 19:19 |
|
#2 |
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
post pic whr you need inflation and error you are getting
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 10:00 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
CFX13 Post Periodic interface | EtaEta | CFX | 7 | December 8, 2011 17:15 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |