|
[Sponsors] |
[ICEM] Problems with edge meshing in one edge |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 27, 2020, 09:36 |
Problems with edge meshing in one edge
|
#1 |
New Member
Join Date: Mar 2018
Posts: 2
Rep Power: 0 |
Hey there!
I am trying to mesh MDA 30P 30N multi-element airfoil. I am facing a problem in meshing a particular edge in the block. when I am increasing the no of nodes from 2 to say 20 half of the block disappears. I have tried exporting as Unstructured mesh in fluent but still, it's showing only half the mesh. The problem is with the edge between the trailing edge of main wing the the leading edge of slat. I will be grateful if anyone can help me. Please let me know if any more screenshots are needed! Aditya |
|
May 27, 2020, 12:56 |
|
#2 |
New Member
Join Date: Mar 2018
Posts: 2
Rep Power: 0 |
I was able to do it, there was an extra node on the top side of the slat.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[ICEM] Simple pipe meshing - problems with y+ in CFX | Keizers | ANSYS Meshing & Geometry | 23 | January 15, 2015 08:00 |
[ICEM] Problems with meshing a 3D wing w/winglet | cesarcg | ANSYS Meshing & Geometry | 10 | March 18, 2013 12:12 |
Meshing for Edge | Charles | Main CFD Forum | 0 | October 25, 2008 10:07 |
GAMBIT: Assumption of an edge type while meshing | Agnes | FLUENT | 0 | June 22, 2005 13:37 |