|
[Sponsors] |
November 13, 2020, 17:01 |
ICEM CFD Segmenting curve by point
|
#1 |
New Member
M
Join Date: Nov 2020
Posts: 7
Rep Power: 5 |
Hi,
I'm new to this website so my apologies if this isn't the correct way to ask this question, I would appreciate any advice on the right way to use the forum. In ANSYS ICEM CFD, I am trying to segment a circular curve by two points on the curve however I am getting the error that it could not split the curve. Is this because I concatenated several curves to make the circle beforehand? Thank you for your help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Generating Hexa-Core with ICEM CFD Interactive | dawdybishop | ANSYS Meshing & Geometry | 1 | October 31, 2017 20:50 |
[ICEM] Reply script in ICEM CFD location use location of geometry point | karamski | ANSYS Meshing & Geometry | 2 | August 13, 2014 11:08 |
Learn ANSYS ICEM CFD | easy_astronaut | ANSYS | 2 | December 15, 2013 15:34 |
ICEM CFD use for ? | Vu Trinh Tuan | CFX | 14 | April 11, 2011 18:38 |
[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent | ivanddd | ANSYS Meshing & Geometry | 1 | February 3, 2011 00:51 |