 |
 |
 |
|
|
|
[Sponsors] | ||||
May 13, 2021, 16:14
|
Element Order not Followed
|
#1 |
|
New Member
Aspa
Join Date: May 2021
Posts: 2
Rep Power: 0  |
I am modelling a simple duct in CFX, and i am trying to set the element order in the mesh as Program Controlled or Quadratic. However, every time when i check the number of nodes in CFX-Post or CFX-Solver the number always remains the same, equal to the one that corresponds to Linear Element order. How can i maintain the Element order i chose in the meshing step ?
|
|
|
|
|
 |
| Tags |
| cfx & fluent, element type, meshing 3d, node number, order |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| can you tell me best gradient, pressure & momentum order selection in fluent | sanjiiv | FLUENT | 6 | February 14, 2020 06:07 |
| [Gmsh] 3D Mesh conversion from gmsh-2.5.0 to OpenFOAM | Ancioi | OpenFOAM Meshing & Mesh Conversion | 17 | January 8, 2019 23:50 |
| How grid resolution for a wave number depends on the scheme order? | marinkobezu | Main CFD Forum | 9 | September 21, 2017 12:11 |
| upwind finite volume order of accuracy less than one ?? | dgfem | Main CFD Forum | 7 | June 1, 2015 04:02 |
| Two way Fsi Problem- Non linear problem | kmgraju | CFX | 4 | April 28, 2015 11:15 |
Linear Mode
