 |
 |
 |
|
|
|
[Sponsors] | ||||
September 1, 2009, 10:52
|
Splitting edge of block
|
#1 |
|
Senior Member
Ryne Whitehill
Join Date: Aug 2009
Posts: 312
Rep Power: 19  |
Hi all:
I had a quick question about splitting the edge of blocks with Auto-pick mode turned on in ICEM v11 Occasionally if I have auto pick mode ON and am using the Prescribed Point split method, when I select an edge it automatically picks a point. From my understanding of auto-pick mode, it should automatically prompt me to pick a point, not select one for me. As it stands, I always have to turn off auto-pick mode to split block edges, which is an annoyance. Any insight into this problem? Thanks in advance, Ryne |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 13:13 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| [Commercial meshers] Star mesh import problem | chris1980 | OpenFOAM Meshing & Mesh Conversion | 20 | May 8, 2006 01:07 |
Linear Mode
